+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Incra Miter Gauge on Hammer K3?? (/showthread.php?tid=7334080)
Incra Miter Gauge on Hammer K3?? - Israel - 10-17-2017
Hello,
Wondering if anyone has tried to modify an Incra miter gauge to fit in the slot on a Hammer K3... and if so, how?
Thanks!
RE: Incra Miter Gauge on Hammer K3?? - Lumber Yard® - 10-18-2017
(10-17-2017, 11:46 PM)Israel Wrote: Hello,
Wondering if anyone has tried to modify an Incra miter gauge to fit in the slot on a Hammer K3... and if so, how?
Thanks!
I haven't done it but IIRC Incra can/will make custom miter bars for different tablesaws that then will fit onto their standard miter gauge heads. You might want to shoot them an email with the Hammer's miter slot dimensions and see what they say.
RE: Incra Miter Gauge on Hammer K3?? - JGrout - 10-18-2017
I doubt it would be too hard
Take the head off the miter bar on the incra then using the existing parts from the CC on the slider figure out how to fit them together
the only thing you really need is the locking nut that goes in the slider and the detent point. If it was me I would mock up a "BAR" out of wood to figure out the important locations then either use aluminum bar to fabricate one or take it to a machinist to make one from steel
Joe
RE: Incra Miter Gauge on Hammer K3?? - Phil B - 10-20-2017
(10-18-2017, 08:15 AM)Lumber Yard® Wrote: I haven't done it but IIRC Incra can/will make custom miter bars for different tablesaws that then will fit onto their standard miter gauge heads. You might want to shoot them an email with the Hammer's miter slot dimensions and see what they say.
there is this:
http://benchmark.20m.com/tools/HammerB3/B3IncraMiterFence/b3_incramiterfenceinstall.html
RE: Incra Miter Gauge on Hammer K3?? - Derek Cohen - 10-21-2017
I think that this is what you are looking for: http://benchmark.20m.com/tools/HammerB3/B3IncraMiterFence/b3_incramiterfenceinstall.html
Regards from Perth
Derek
RE: Incra Miter Gauge on Hammer K3?? - Israel - 10-23-2017
(10-21-2017, 03:54 AM)Derek Cohen Wrote: I think that this is what you are looking for: http://benchmark.20m.com/tools/HammerB3/B3IncraMiterFence/b3_incramiterfenceinstall.html
Regards from Perth
Derek
Thanks for forwarding the link--very helpful!!