+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: My panel glue up table top (/showthread.php?tid=7336584)
My panel glue up table top - Stwood_ - 01-19-2018
is about used up I think. 10-15 years of gluing up door panels has filled it in with a lot of glue.
Time to make a new one I think. It's close to an inch deep in the middle.
Wonder how hot the old one will burn in the woodstove?
[attachment=7389][attachment=7390]
RE: My panel glue up table top - AgGEM - 01-19-2018
Wow
Someone here has the tag line "you are not your post count".
But I think you could get extra credit for your glue droppings.
In some circles, it could be "high art".
Ag
RE: My panel glue up table top - Joel H. - 01-19-2018
(01-19-2018, 07:14 PM)AgGEM Wrote: Wow
Someone here has the tag line "you are not your post count".
But I think you could get extra credit for your glue droppings.
In some circles, it could be "high art".
Ag
When I first looked at the photos, I thought that was carpeting and couldn't figure out why you'd put carpet on a glue-up top. Then Ag's comment made me look again. Wow that is amazing. I'll even bet you used to clean the glue droppings off it.
Joel
RE: My panel glue up table top - EdL - 01-19-2018
I'm calling the EPA.......
Ed
RE: My panel glue up table top - Stwood_ - 01-19-2018
(01-19-2018, 09:33 PM)EdL Wrote: I'm calling the EPA.......
Ed
RE: My panel glue up table top - Wild Turkey - 01-20-2018
If you like the setup I'd attack it with a wide chisel and mallet and knock most of it off and start over
Or a belt sander on slow speed and 40 grit belt.
Got an air chisel? That might make quick work of it.
RE: My panel glue up table top - Bob10 - 01-20-2018
(01-19-2018, 07:05 PM)Stwood_ Wrote: is about used up I think. 10-15 years of gluing up door panels has filled it in with a lot of glue.
Time to make a new one I think. It's close to an inch deep in the middle.
Wonder how hot the old one will burn in the woodstove?
Did you give it a go with a heat gun and wide knife
Oh I know how to fix it!! I have to find a picture
![[Image: FN1KDGSIDBHXS11.MEDIUM.jpg]](https://cdn.instructables.com/FN1/KDGS/IDBHXS11/FN1KDGSIDBHXS11.MEDIUM.jpg)
RE: My panel glue up table top - Stwood_ - 01-20-2018
(01-20-2018, 04:34 PM)Wild Turkey Wrote: If you like the setup I'd attack it with a wide chisel and mallet and knock most of it off and start over
Or a belt sander on slow speed and 40 grit belt.
Got an air chisel? That might make quick work of it.
That bottom board is 1/2 chipboard, and may not survive the chisel.
I can probably build a new one in less time.
(01-20-2018, 04:57 PM)Bob10 Wrote: Did you give it a go with a heat gun and wide knife
Oh I know how to fix it!! I have to find a picture
Router sled.