+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Daily Bench Shot (/showthread.php?tid=7336585)
Pages:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
RE: Daily Bench Shot - ®smpr_fi_mac® - 02-14-2021
I built a motor cover for my old, yet new-to-me Unisaw.
RE: Daily Bench Shot - Stwood_ - 02-15-2021
I did that on my grizzly. Put hinges and a latch on it. Closed that hole off so the collector could work.
RE: Daily Bench Shot - Stwood_ - 02-19-2021
[attachment=33413]
RE: Daily Bench Shot - Stwood_ - 02-24-2021
[attachment=33559]
RE: Daily Bench Shot - Aram - 02-24-2021
Coopered door, first try, cheap wood.
![[Image: i-S5v8mQG-M.jpg]](https://photos.smugmug.com/photos/i-S5v8mQG/0/0e769808/M/i-S5v8mQG-M.jpg)
RE: Daily Bench Shot - Rob Young - 03-08-2021
Didn't have phone in pocket when it was down on the bench, but modified J. & L.J. Stickley #516 is done.
The #516 is almost a cube but this has been modified to be a bit taller and is deeper than wide. Dad needs a relatively large table next to his recliner. Wants to move his printer over to be at the back of this table and still have places to set things.
Quarter sawn red oak (rather mild rays in this batch).
Mostly an exercise in pre-finishing because this is nothing but inside right-angles! I have a few spots to touch up yet but otherwise, done.
Poorly lit & cropped cell phone photos:
[attachment=33891]
[attachment=33892]
[attachment=33893]
[attachment=33894]
RE: Daily Bench Shot - Stwood_ - 03-08-2021
[attachment=33895]
RE: Daily Bench Shot - jstraw - 03-08-2021
Real nice job on the table. Dad will enjoy it.
RE: Daily Bench Shot - R Clark - 03-08-2021
Up next...get my old 30HP outboard going so I can sell it.
[attachment=33909]
RE: Daily Bench Shot - Stwood_ - 03-14-2021
[attachment=34117]