+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Just found a tool that may help us with turning (/showthread.php?tid=7338443)
Just found a tool that may help us with turning - Arlin Eastman - 03-26-2018
It is an off set Taper Metal Turning Attachment in 3MT Shank for Off-setting Lathe's Tailstock.
https://www.amazon.com/dp/B06X6CY9VV/ref=sspa_dk_detail_4?psc=1&pd_rd_i=B06X6CY9VV&pd_rd_wg=C6H8Q&pd_rd_r=EBKN5GRJ26252GQNCFS8&pd_rd_w=Dywrp
If you do a lot of off set work this may help. I am thinking of getting it in the future.
What do you think?
RE: Just found a tool that may help us with turning - Timberwolf - 03-26-2018
(03-26-2018, 08:03 PM)Arlin Eastman Wrote: It is an off set Taper Metal Turning Attachment in 3MT Shank for Off-setting Lathe's Tailstock.,,,,,,,,
https://www.amazon.com/dp/B06X6CY9VV/ref=sspa_dk_detail_4?psc=1&pd_rd_i=B06X6CY9VV&pd_rd_wg=C6H8Q&pd_rd_r=EBKN5GRJ26252GQNCFS8&pd_rd_w=Dywrp
If you do a lot of off set work this may help. I am thinking of getting it in the future.
What do you think?
Looks like it has a #3 Morse taper, Arlin...What size does your lathe have? My wood lathes have a #2 in both headstock and tailstock...My metal lathes have #3 Morse in the headstock..
RE: Just found a tool that may help us with turning - Woodshop - 03-27-2018
(03-26-2018, 08:03 PM)Arlin Eastman Wrote: It is an off set Taper Metal Turning Attachment in 3MT Shank for Off-setting Lathe's Tailstock.
https://www.amazon.com/dp/B06X6CY9VV/ref=sspa_dk_detail_4?psc=1&pd_rd_i=B06X6CY9VV&pd_rd_wg=C6H8Q&pd_rd_r=EBKN5GRJ26252GQNCFS8&pd_rd_w=Dywrp
If you do a lot of off set work this may help. I am thinking of getting it in the future.
What do you think?
It only helps if you have a carriage to run your tool bits. Then you get a long taper.
You can do the same with a wood lathe by putting a stop on the turning tool and angle the tool rest . much easier
RE: Just found a tool that may help us with turning - Arlin Eastman - 03-27-2018
(03-27-2018, 08:56 AM)Woodshop Wrote: It only helps if you have a carriage to run your tool bits. Then you get a long taper.
You can do the same with a wood lathe by putting a stop on the turning tool and angle the tool rest . much easier
Don
I am not following your direction of thought. Can you explain it in an easier way for me.