+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Box bottom technique (/showthread.php?tid=7340091)
Box bottom technique - Jack in omaha - 06-08-2018
I am going to make a box for my Lion Trimmer. It is very sharp and fairly heavy so i want it safely enclosed for storage.
It has a good deal of heft so please give me the best way to attach design the bottom and what thickness.
RE: Box bottom technique - giradman - 06-08-2018
(06-08-2018, 09:38 AM)Jack in omaha Wrote: I am going to make a box for my Lion Trimmer. It is very sharp and fairly heavy so i want it safely enclosed for storage.
It has a good deal of heft so please give me the best way to attach design the bottom and what thickness.
Hi - Jack - assume that you mean the type of miter trimmer shown below? Use a bathroom scale and tell us how much it weighs? I suspect that dado lower sides w/ at least 3/8" to 1/2" thick bottom would likely work - my main concern is how to remove the trimmer from the box w/o cutting one's fingers, i.e. opening top cover or a side opening to slide the cutter out? Good luck - Dave
.
RE: Box bottom technique - Hank Knight - 06-08-2018
Baltic birch plywood is amazingly strong. You could easily get away with a 1/4" BB ply bottom set in grooves in the front back and sides of your box. If you don't trust 1/4" stock, 3/8" BB ply would be more than strong enough. I used 3/8" BB ply for bottoms in my large shop drawers. They're a lot bigger than the box you'll need for your Lion Miter Trimmer, and they have held a lot of weight with no issues.
RE: Box bottom technique - Alan S - 06-08-2018
While you could do as Hank Knight says, another option would be to make the bottom of heavier stock, and bolt the trimmer to it. Make the rest of the box as a cover that fits over and latches securely. That way you can carry the entire box safely to where you will use it, then unlatch and remove the cover for use.
RE: Box bottom technique - jppierson - 06-08-2018
(06-08-2018, 03:09 PM)Alan S Wrote: While you could do as Hank Knight says, another option would be to make the bottom of heavier stock, and bolt the trimmer to it. Make the rest of the box as a cover that fits over and latches securely. That way you can carry the entire box safely to where you will use it, then unlatch and remove the cover for use.
+1 This is a similar technique for other heavy items such as sewing machines and movie projectors.
RE: Box bottom technique - handi - 06-08-2018
(06-08-2018, 03:09 PM)Alan S Wrote: While you could do as Hank Knight says, another option would be to make the bottom of heavier stock, and bolt the trimmer to it. Make the rest of the box as a cover that fits over and latches securely. That way you can carry the entire box safely to where you will use it, then unlatch and remove the cover for use.
I would do this ^^^^ the base will give you an easy way to clamp down the trimmer in use as well.