Sliding saw update - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Sliding saw update (/showthread.php?tid=7347114) |
RE: Sliding saw update - stav - 03-28-2019 Those are some really nice upgrade Derek. RE: Sliding saw update - jimmyjam - 03-28-2019 (03-27-2019, 06:53 PM)Derek Cohen Wrote: I also built a jig for mitres ... Derek, what are you using for mounts for the pivot points for the miter jig? Jay RE: Sliding saw update - Derek Cohen - 03-28-2019 There is a bolt near the pointy end into the track. At the opposite end, on the curve, a locking plate is bolted to the track that runs the length of the side of the slider ... Regards from Perth Derek RE: Sliding saw update - Tony Z - 03-28-2019 Beautiful work, Derek! RE: Sliding saw update - sampson801 - 04-30-2019 (03-27-2019, 06:53 PM)Derek: Very nice! Did you document the building of each of the accessories that you listed?If so, will you provide the links?Thank you.Robert Derek Cohen Wrote: I have the same slider. If you did not have a router table, I would have suggested doing as I did ... although you may still want to make this mod ... RE: Sliding saw update - Derek Cohen - 05-01-2019 No documentation - my website is mainly for handtools and their use. I did post about these on SMC some while back. Regards from Perth Derek RE: Sliding saw update - Cian - 05-02-2019 Impressive machine................ RE: Sliding saw update - Jason28 - 06-19-2019 (03-27-2019, 06:53 PM)Derek Cohen Wrote: Lastly, I added a Wixey to the rip fence (which is used along with a F&F jig) .. Having been laid up with a bad back (again) I've been revisiting this thread for ideas. I was set to get some components from Lee Valley to build my Fritz and Franz, but then I zeroed in on the F&F you've got Derek. I'm curious what your reasoning for the Incra components was (though I suspect it's the accuracy or repeatability or both). I tend to use set measurements only for initial components then switch to making the pieces fit for the rest of the project, so I'm a little hesitant to lock myself into set measurements. But on the other had, being able to return to an exact setting is appealing. Thoughts? RE: Sliding saw update - Derek Cohen - 06-21-2019 Jason, the reason for the scales is that it enables accurate rips (this is not critical - there are other ways to set depth). The Incra fence and stops take up length space. Regards from Perth Dere RE: Sliding saw update - Jason28 - 06-21-2019 (06-21-2019, 07:42 AM)Derek Cohen Wrote: Jason, the reason for the scales is that it enables accurate rips (this is not critical - there are other ways to set depth). The Incra fence and stops take up length space. I suppose they do, don't they. Do you find them limiting in practice? Would you use them again or go a different route? |