Wood putty popping under latex paint - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Wood putty popping under latex paint (/showthread.php?tid=7347400) Pages:
1
2
|
RE: Wood putty popping under latex paint - Phil Thien - 03-30-2019 (03-30-2019, 04:40 PM)Stwood_ Wrote: That looks more like a wood plug than putty on my end. Course sometimes my end can get distorted if my ozone depletion coptoviro system is malfunctioning...... I had the same thought, about the wood plug and not the ozone whatever. RE: Wood putty popping under latex paint - ®smpr_fi_mac® - 03-30-2019 Ha! It's putty. I applied it! RE: Wood putty popping under latex paint - Cooler - 04-02-2019 I would chip out the wood putty and replace it with acrylic spackle. It sands easier and coats well. They claim it does not even require sanding. RE: Wood putty popping under latex paint - Roly - 04-02-2019 I would sand it flush the coat the whole face with shellac so the surface will be uniform. Roly RE: Wood putty popping under latex paint - Cooler - 04-02-2019 (03-30-2019, 04:43 PM)Phil Thien Wrote: I had the same thought, about the wood plug and not the ozone whatever. If you plug a countersunk and counter bored hole with putty, it will expand out looking like a overlength dowel. RE: Wood putty popping under latex paint - crokett™ - 04-02-2019 (04-02-2019, 08:07 AM)Cooler Wrote: They claim it does not even require sanding. "they" lie. RE: Wood putty popping under latex paint - Cooler - 04-02-2019 (04-02-2019, 12:38 PM)crokett™ Wrote: "they" lie.I installed ship lap in one bathroom. Contrary to standard practice I filled all the nail holes with spackle (and sanded). Under a coat of primer and a coat of Behr Marquis semi-gloss it is quite impossible to spot the holes. These were just 18 gage and a few 15 gage nail holes. Much smaller than a countersunk screw hole. But it dried fast, sanded fast and easily and was invisible after painting. I used Shop Smith sanding blocks with velcro sand paper. After the sand paper clogs up I run it under a strong stream of hot water and it is good to go again once dry. The small block seems perfect for small holes. RE: Wood putty popping under latex paint - ®smpr_fi_mac® - 05-14-2019 Update: I sanded down the popped putty and repainted with latex paint that I *didn't* thin with water. No issues. RE: Wood putty popping under latex paint - Stwood_ - 05-14-2019 ................... |