Mak'n due.... - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Mak'n due.... (/showthread.php?tid=7348082) Pages:
1
2
|
Mak'n due.... - justdraftn - 05-06-2019 with what you have. Building a fence around my garden. Custom cut pickets. Needed some king posts for corners and transitions. Had a few treated 2x8s that I scrounged a couple of years ago. Ripped them to 3", treated the below ground w/some left over asphalt sealer and tops w/Thompsons. Screwed them together to make 3x3s. Cut a little detail on the tops to match the pickets. Not bad for some crappy old 2x8s. RE: Mak'n due.... - K. L. McReynolds - 05-06-2019 !!!!!!!!!!! RE: Mak'n due.... - Stwood_ - 05-09-2019 Pointed the bottoms for what reason? Post driver?? How did you fashion the tops? Looks like the center (thinnest part) is rounded? Can't quite tell from your picture RE: Mak'n due.... - justdraftn - 05-09-2019 (05-09-2019, 01:29 PM)Stwood_ Wrote: Yes. I'll clamp a couple of scrap 2x4s and drive them w/a 2x4. May dig half way w/post hole digger. Pretty high tech build. Created a cardboard template. Traced it onto each side/edge. Cut them on the bandsaw. Took about 20min to cut them all. RE: Mak'n due.... - Stwood_ - 05-09-2019 Oh the ol' high tech cardboard trick. USA or China cardboard? Looks good. RE: Mak'n due.... - justdraftn - 05-11-2019 First post set/first sections of fence set. Just as planned. I love it when a plan comes together. Only 170' to go. RE: Mak'n due.... - Stwood_ - 05-11-2019 ...................... RE: Mak'n due.... - museumguy - 05-12-2019 You know, I never know what to expect from a thread topic. I was quite pleased by this one, . Great use of left over material, I really like the design but the end result is even better, very nice. RE: Mak'n due.... - justdraftn - 05-12-2019 (05-12-2019, 07:58 AM)museumguy Wrote: You know, I never know what to expect from a thread topic. I was quite pleased by this one, Thanks! I'm having way too much fun. RE: Mak'n due.... - museumguy - 05-12-2019 (05-12-2019, 04:17 PM)justdraftn Wrote: I'm having way too much fun. Isn't that the point !!!! Keep doing it, smiles are great |