+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Demonstrating the Knew Concepts fretsaw (/showthread.php?tid=7348395)
Demonstrating the Knew Concepts fretsaw - Derek Cohen - 05-25-2019
While working on the current build (I will post this later), I took a couple of minutes to make a very short video using a Knew Concepts fretsaw to remove the waste from pins. The purpose is to demonstrate how efficient this process is, as compared with chopping the waste out. Note that the wood is 20mm thick Hard Maple (it is indeed very hard wood!). These are mitred through dovetails for the carcase of a side table with drawers.
Regards from Perth
Derek
RE: Demonstrating the Knew Concepts fretsaw - Timberwolf - 05-25-2019
(05-25-2019, 07:48 AM)Derek Cohen Wrote: While working on the current build (I will post this later), I took a couple of minutes to make a very short video using a Knew Concepts fretsaw to remove the waste from pins. The purpose is to demonstrate how to efficient this process is, as compared with chopping the waste out. Note that the wood is 20mm thick Hard Maple (it is indeed very hard wood!). These are mitred through dovetails for the carcase of a side table with drawers..............................
Regards from Perth
Derek
You make it look easy, Derek...but I know how much "sawing skill" it takes....I used to pierce coins in the "olden days" and I went through lots of blades in learning to handle the saw and let the tiny blade do the work...No doubt the rigid titanium frame helps tremendously...a "slack" blade leads to a short life...
Thank you for the video...
RE: Demonstrating the Knew Concepts fretsaw - TraditionalToolworks - 05-28-2019
AFAICT, that's almost identical to how Rob Cosman shows to use the fretsaw.
I do wish I owned one of those Knew Concept saws, but something I never picked up and just use an inexpensive fret saw that works fine. Lee was a great guy (R.I.P.) who I exchanged a fair amount of email with in the past, he used to hang out on Practical Machinists before he passed. Brian still hangs out there.
Anybody try the Blue Spruce coping saw that Dave came out with?