Woodnet Forums
SOLD 5/8" Jacobs chuck + arbor + key - Printable Version

+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: SOLD 5/8" Jacobs chuck + arbor + key (/showthread.php?tid=7348833)



SOLD 5/8" Jacobs chuck + arbor + key - Aram - 06-17-2019

I bought this off of eBay, then realized it is 5/8", instead of the 1/2" version I wanted. Someone give this a good home.

Jacobs chuck, used but in very good shape. It turns easily by hand but is not at all loose. I chucked up a 1/2" gauge pin, put a travel gauge on it, and spun it by hand. 0.001" total runout. Crazy, just dead nuts.

I'm including the MT2 JT3 arbor I bought from Amazon. 

SOLD

[Image: i-vn2sQjG-M.jpg]
[Image: i-MhMqWKv-M.jpg]
[Image: i-KDW8tqG-M.jpg]


RE: 5/8" Jacobs chuck + arbor + key - Timberwolf - 06-17-2019

(06-17-2019, 06:03 PM)Aram Wrote: I bought this off of eBay, then realized it is 5/8", instead of the 1/2" version I wanted. Someone give this a good home.

Jacobs chuck, used but in very good shape. It turns easily by hand but is not at all loose. I chucked up a 1/2" gauge pin, put a travel gauge on it, and spun it by hand. 0.001" total runout. Crazy, just dead nuts.

I'm including the MT2 JT3 arbor I bought from Amazon. 

This cost my $163 off of eBay. Yours for $130 including shipping, CONUS only.

[Image: i-vn2sQjG-M.jpg]
[Image: i-MhMqWKv-M.jpg]
[Image: i-KDW8tqG-M.jpg]
..............
I didn't check to see but I believe that is the ball-bearing super chuck...and it is aptly named IMO....One of the best they make!!!!


RE: 5/8" Jacobs chuck + arbor + key - sniper - 06-17-2019

JT3 not a JT33 correct? I need a new chuck for my drillpress but it's a 33. I'll take it if it's a 33.

Never mind, just looked a little closer at your last pic. Oh well.