Need some Cork for carving tools - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Need some Cork for carving tools (/showthread.php?tid=7352274) |
Need some Cork for carving tools - Arlin Eastman - 01-09-2020 We need about 40 - 60 of them so we can put the carving chisels into them to protect the sharp ends. Can pay shipping Thanks Just PM me for address RE: Need some Cork for carving tools - sniper - 01-10-2020 (01-09-2020, 10:30 PM)Arlin Eastman Wrote: We need about 40 - 60 of them so we can put the carving chisels into them to protect the sharp ends. If y'all don't drink wine (I'm guessing you don't), check the local restaurant(s) that serve wine and ask if they could save the corks for you. Just a thought. RE: Need some Cork for carving tools - Arlin Eastman - 01-10-2020 Thanks Bill in handtools said the same thing and I will call a few places to see who serves it. RE: Need some Cork for carving tools - Ohio Mike - 01-10-2020 (01-09-2020, 10:30 PM)Arlin Eastman Wrote: We need about 40 - 60 of them so we can put the carving chisels into them to protect the sharp ends. I've been using scraps of rigid foam insulation. Works great! RE: Need some Cork for carving tools - Arlin Eastman - 01-11-2020 (01-10-2020, 06:28 PM)Ohio Mike Wrote: I've been using scraps of rigid foam insulation. Works great! Thanks Mike. How firmly do they hold the blade? RE: Need some Cork for carving tools - Ohio Mike - 01-11-2020 They hold very well. I make sure to put them on the tool in the same orientation each time. That way I'm not cutting a second slot in the foam. I imagine the same rule applies to cork as well. Mike RE: Need some Cork for carving tools - Timberwolf - 01-12-2020 (01-11-2020, 02:17 PM)Ohio Mike Wrote: They hold very well. .......................... Too many knives to worry about RE: Need some Cork for carving tools - Ohio Mike - 01-12-2020 (01-12-2020, 11:02 AM)Timberwolf Wrote: .......................... That's impressive. You would need a full sheet of rigid foam to make sheaths for all those tools! RE: Need some Cork for carving tools - Arlin Eastman - 01-12-2020 [attachment=22879] |