Downdraft Table? - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Downdraft Table? (/showthread.php?tid=7352365) |
Downdraft Table? - Stamper - 01-15-2020 Am in the process of making a downdraft table and have a few questions. Table will be approx. 24"x 48". Am wondering about what size and spacing of holes, any suggestions? RE: Downdraft Table? - brianwelch - 01-15-2020 I have seen, and used, 1/4" th. masonite pegboard for the surface...approx 3/16"-->1/4" diameter holes on 1" grid... RE: Downdraft Table? - teetomterrific - 01-15-2020 (01-15-2020, 11:21 AM)Stamper Wrote: Am in the process of making a downdraft table and have a few questions. Table will be approx. 24"x 48". Am wondering about what size and spacing of holes, any suggestions? Based on the dimensions in the Grizzly T10699 - Downdraft Table Kit "Each panel measures 6-3/4" W x 16-1/2" L" and there are 4 holes within the 6-3/4 width I would guess the hole width is somewhere between 3/4 and 7/8 It looks like the edges on these panels are approximately half the width of the space between the holes. Doing the math it looks like the holes are 7/8 and the spaces are 13/16 but it could be vice versa. If it were me I'd just buy these panels and build the downdraft box around them. |