+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: pipe dope on hot water heater (/showthread.php?tid=7352594)
Pages:
1
2
pipe dope on hot water heater - CEPenworks - 01-26-2020
So I just replaced my hot water heater and the female threaded fitting going onto the dielectric nipple coming out of the water heater will not seal up. I first reused the old one then when that leaked I got a new one. Our code requires hard pipe so no easy flex trials so each time I want to change something I have to cut the pipe again. On another water project earlier this year I had the same problem with a threaded connection. I ended up getting some T plus 2 pipe dope and that finally sealed it up. Is there any reason I can't use this on the water coming out of the water heater? I am also thinking I will get a slip union to put in this pipe just incase this takes some more trials.
RE: pipe dope on hot water heater - Stwood_ - 01-26-2020
Either dope or tape, I use what is handy. Usually tape as I have a big supply.
I wouldn't think twice about putting a union on those pipes.
RE: pipe dope on hot water heater - Phil Thien - 01-26-2020
Sure you can use T Plus 2, that is exactly what I'd be doing. Tape doesn't work great on new threads unless both sides were cut by the same vendor, IMHO.
RE: pipe dope on hot water heater - John Mihich - 01-26-2020
I have never replaced a WH without having to redo the hot water side. I put pipe dope on them all the time and I still have to redo them - only the hot water side.
RE: pipe dope on hot water heater - Bluepine - 01-26-2020
A good friend is a well driller, all joints get 2 wraps of Teflon and pipe dope. No call backs.
RE: pipe dope on hot water heater - jteneyck - 01-26-2020
I have much better luck with pipe dope than tape. I put unions and shut off valves in both the hot and cold lines to the hot water heater so swapping out the old for a new one, or dealing with a leak like you have, is less of a hassle.
John
RE: pipe dope on hot water heater - fixtureman - 01-27-2020
Can you not use a union so you don't have to cut the pipe
RE: pipe dope on hot water heater - CEPenworks - 01-28-2020
I can't get a break with this project. I put on the union and applied pipe dope to the threaded connection to the water heater. The threaded connection leaked so at least I was able to disconnect the union and give the threaded connection a little more twist. Now I noticed the union is weeping just a little. I am thinking of loosening the nut and wiping some pipe dope around where the two pieces come together. I hope that will finally seal this thing up.
RE: pipe dope on hot water heater - Snipe Hunter - 01-28-2020
Rector Seal - Tru Blue
RE: pipe dope on hot water heater - DustyDan - 01-31-2020
I have had unions leak before, an ocasional drip.
My fix was to give it a few days and the leak creates enough corrosion to "heal" the leak. This is only a once in a while sort of thing. Not very professional but when ample tape and tightening doesn't seem to work it went away on it's own.