+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: finally got lathe time (/showthread.php?tid=7352967)
finally got lathe time - PVW - 02-16-2020
curly silver maple and quilt. large bowl is 14 x 4
[attachment=24098]
RE: finally got lathe time - SceneryMaker - 02-16-2020
Very pretty. I like the clean lines.
RE: finally got lathe time - Turner52 - 02-16-2020
That grain really pops. Great job
RE: finally got lathe time - Arlin Eastman - 02-16-2020
That is some swell looking wood and the form looks great as well. Thanks for showing.
RE: finally got lathe time - FrankAtl - 02-18-2020
Beautiful work Mike. I love the quilted maple!
RE: finally got lathe time - med-one - 02-20-2020
PVW,
How long did your bowl wood dry before your turned them?
Dave
RE: finally got lathe time - PVW - 02-20-2020
(02-20-2020, 11:19 AM)med-one Wrote: PVW,
How long did your bowl wood dry before your turned them?
Dave
it varies. Year or more. I like to give them a minimum of 2 years .I have 5 in thick cherry slabs that have been cut and stickered for 7 years. I'd like to start turning some but the biggest ones are 20 wide and 8' long, and I just don't feel like man handling them right now .I like to turn dry wood for the most part. The silver maple has been in the shop for around 4 years. I have a 14 in green cherry burl blank that I hope to turn yet this week. I will also plan to use the Bartleys on it. Depends on how it feels
RE: finally got lathe time - MichaelMouse - 02-24-2020
(02-20-2020, 11:19 AM)med-one Wrote: PVW,
How long did your bowl wood dry before your turned them?
Dave
Since it's been without comment for so long, I'll jump in with the standard TDT (Turn/Dry/Turn) recommendation. Turn the piece to rough pattern, somewhere around 5/8 to 1" thickness, and take advantage of the fact that wood looses water through end grain 10 times as fast as face grain. When you rough turn, be sure to round down to the bottom - no "dog dish" pattern- to minimize the face-grain dimension, thus split menace. Continuous curve helps redirect drying stress as well.
I'm a mortise hold guy, and lazy to boot, so I don't do weights and dates, I just measure mortise deformation to estimate readiness. On almost any wood, a shrink of 1/8" across a 2" mortise means the piece is ready for re-turn. Depending on Relative Humidity and thickness, six weeks give or take. Gets the shelf space back to you a lot earlier than a year, risking deep checks. 10-12% cross-grain shrink should be fine even if you're a tenon guy.
RE: finally got lathe time - cbygeorge - 02-27-2020
Mike, nice to see you on here again! Nice work! Hope you and your better half are well. Also hope to see you at Bedford this fall.
Chuck
RE: finally got lathe time - PVW - 02-28-2020
(02-27-2020, 10:43 PM)cbygeorge Wrote: Mike, nice to see you on here again! Nice work! Hope you and your better half are well. Also hope to see you at Bedford this fall.
Chuck
Hey Chuck. We missed you last fall at Bedford. Are you still carving?