+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Black Veneer (/showthread.php?tid=7354994)
Black Veneer - jcredding - 05-02-2020
I’m going to do a segmented piece with ebony accents (base and rim), and would like 1/32” black between each piece and each row. Curious what others have used (ebony vs. something dyed black) and any recommended suppliers.
Thanks,
John
RE: Black Veneer - MichaelMouse - 05-02-2020
(05-02-2020, 08:34 AM)jcredding Wrote: I’m going to do a segmented piece with ebony accents (base and rim), and would like 1/32” black between each piece and each row. Curious what others have used (ebony vs. something dyed black) and any recommended suppliers.
Walnut, with the end grain toward the surface should fill the bill, and is available most anywhere.
RE: Black Veneer - SteveS - 05-02-2020
B&B Rare Woods
That's where I buy most of my veneer, dyed or natural.
RE: Black Veneer - Arlin Eastman - 05-02-2020
I go to Menards and use this and dye it.
https://www.menards.com/main/doors-windows-millwork/dowels-wooden-pins-plugs/midwest-products-reg-1-16-x-6-x-24-basswood-sheet/64125/p-1458270028882-c-12188.htm
RE: Black Veneer - SteveS - 05-02-2020
(05-02-2020, 10:43 AM)Arlin Eastman Wrote: I go to Menards and use this and dye it.
https://www.menards.com/main/doors-windows-millwork/dowels-wooden-pins-plugs/midwest-products-reg-1-16-x-6-x-24-basswood-sheet/64125/p-1458270028882-c-12188.htm
The wood alone is more expensive than the already dyed sheets.
RE: Black Veneer - Arlin Eastman - 05-02-2020
(05-02-2020, 04:37 PM)SteveS Wrote: The wood alone is more expensive than the already dyed sheets.
Steve
I do not know why it does not show it, but the package has 3 of them. There is a 1/32 one also but it did not show it either and it is a pack of 4 for about the same price..
All I do is put them in a 73qt stock pan and let them soak in the ink or dye for 5 minutes and dry them off and let them set for a few days with a weight on the whole surface.
I do a complete different job on the roses I make. I use Aldine dye for those.
RE: Black Veneer - Arlin Eastman - 05-10-2020
John & Steve
OK I finally found the piece I was talking about with the sticker still on it.
Called
Birch Ply
"Nominal"
1/32" x 12" x 24"
Made in USA
Of Global Materials
They also have 1/8" and 1/16"
Last I use both the 1/32" and 1/16" to burn grooves instead of wire (I typed wife so thought I better change it
). So much easier and safer to. I have not tried 1/8" since it seems to wide to burn a groove with but maybe someday if it may look good I will give it a try.I have used a 2x6 pine board to burn the top of a few boxes before and it sure woods good doing that.
RE: Black Veneer - jcredding - 05-10-2020
Thanks Arlin. I ended up buying some from B&B Rare Woods for the next project. It was pretty cost effective and they were very helpful.
Thanks for the referral, Steve.