SawStop PCS - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: SawStop PCS (/showthread.php?tid=7355347) |
SawStop PCS - Jim - 05-18-2020 I've looked on the Sawstop site, and used the search function here without satisfying results. Could someone who has a SawStop PCS 3HP with the 52 in fence give me the floor dimensions required for the base and table legs? I'm trying to see if an existing mobile base I have will work. Thank you! RE: SawStop PCS - Tapper - 05-19-2020 Hi Jim, I have a PCS with the smaller footprint (36"?); bought the saw when they released the PCS originally. FWIW I opted for the upgraded base that comes with the ICS saw and am glad I did. It is very stable and works nicely. Whatever base you choose, you will like this saw! Doug RE: SawStop PCS - Brandon C - 05-20-2020 (05-18-2020, 02:21 PM)Jim Wrote: I've looked on the Sawstop site, and used the search function here without satisfying results. Could someone who has a SawStop PCS 3HP with the 52 in fence give me the floor dimensions required for the base and table legs? I'm trying to see if an existing mobile base I have will work. Thank you! The Sawstop site says 85.25" wide by 33" deep. It will be 34" tall. RE: SawStop PCS - rschissler - 05-20-2020 I have that saw and 52" rails, and I measure the footprint base as 18 3/4" by 19 1/4. The table legs are 26 1/4". Don't know why the legs would be part of the mobile base, but if they then 26 1/4" by 84 1/2". I have the PCS mobile base and it works fine. It doesn't move freely in four directions like I think the ICS base does, but it's good enough for me. I rarely have to move it. RE: SawStop PCS - Jim - 05-20-2020 Thanks everyone! I should have put in my original question the reason I was asking for this info. I currently have a General 650 with a 52 inch fence. It sits on an HTC mobile base, which holds both the saw and the legs for the extension table. I would like to use the same mobile base if possible, to save from having to purchase the SS mobile base. I think my General is slightly heavier than the SS. The current mobile base moves with ease. RE: SawStop PCS - fredhargis - 05-20-2020 (05-20-2020, 09:35 AM)Jim Wrote: Thanks everyone! I should have put in my original question the reason I was asking for this info. I currently have a General 650 with a 52 inch fence. It sits on an HTC mobile base, which holds both the saw and the legs for the extension table. I would like to use the same mobile base if possible, to save from having to purchase the SS mobile base. I think my General is slightly heavier than the SS. The current mobile base moves with ease. The Delta mobile base I had under my Unisaw was like that, the extension legs sat in the base. My saw is an ICS so this may be off alittle from a PCS, but the legs are 50 7/8" from the cabinet (52" fence). My cabinet is the width as the PCS..18 3/4", so it should be the correct length. |