Transformations - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Transformations (/showthread.php?tid=7356264) |
RE: Transformations - Derek Cohen - 07-03-2020 I had meant to mention the way I dealt with the dowels, the leg joinery, but there was not the opportunity. Here are the legs, and you can see the ugly dowels. What I did was to turn them upside down, and remove the dowelled section in the taper cut ... First, the legs were morticed .. I built a simple fixture for my sliding table saw ... The nail holes were filled with coloured epoxy, which disappeared after the finish was applied ... And then smoothed ... I was asked (when I posted this photo elsewhere) why I planed into the grain. The answer is ‘because I can with a closed chipbreaker’ No, the real answer is because it was easier to keep track of the mark demarcating the flat section. Regards from Perth Derek RE: Transformations - Tapper - 07-03-2020 Very clever design and execution on the drawer, Derek! And exceptional work as usual - well done! Doug P.S. Did I see "metal" angle braces in the corners? - pure heresy!!! (Just kidding ) RE: Transformations - Ohio Mike - 07-04-2020 (07-03-2020, 10:57 PM)Derek Cohen Wrote: Mike ... Thanks! RE: Transformations - Derek Cohen - 07-04-2020 Rita's table at home ... Regards from Perth Derek RE: Transformations - Phil S. - 07-04-2020 Looks like it was made for it. So---was she pleased? RE: Transformations - Derek Cohen - 07-04-2020 Regards from Perth Derek |