Jointer snipe help please - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Jointer snipe help please (/showthread.php?tid=7357634) Pages:
1
2
|
RE: Jointer snipe help please - rwe2156 - 09-09-2020 Raise the outfeed table a little and do test cuts until the snipe disappears. This works for me with helical head cutters. RE: Jointer snipe help please - Aram - 09-12-2020 (09-08-2020, 07:18 AM)stav Wrote: If I am reading this correctly, it sounds as if the board is dropping into the cutter as it leaves the in feed table. So I would go with the suggestion that the out feed is too low. I am no jointer expert though. (09-09-2020, 09:41 AM)rwe2156 Wrote: Raise the outfeed table a little and do test cuts until the snipe disappears. As I had not removed the infeed table, I did just that, cleaned it, and spent way too much time re-aligning everything. This time, it appears to be dialed in -- I am not seeing snipe. We'll see if it sticks. Thanks for the advice. RE: Jointer snipe help please - sroxberg - 09-12-2020 It sounds like the out feed table is too low, I would ever so slightly raise it. That solved my snipe issue. |