+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: 46 460 lathe bearing replacement (/showthread.php?tid=7360079)
46 460 lathe bearing replacement - Bill Mains - 01-11-2021
Any videos or a set of detailed instructions on how to do a bearing change?
RE: 46 460 lathe bearing replacement - Bill Mains - 02-01-2021
Anybody?
Looked on you tube n othe sites n came up empty handed.
RE: 46 460 lathe bearing replacement - iclark - 02-02-2021
You might try asking over on International Association of Penturners (IAP)
Seems like a bunch of people over there with experience changing those bearings.
RE: 46 460 lathe bearing replacement - Leo Vanderloo - 02-07-2021
(02-01-2021, 08:12 PM)Bill Mains Wrote: Anybody?
Looked on you tube n othe sites n came up empty handed.
Looks pretty easy to me, I have the parts layout here, if you take a close look you see how the parts are in and on the lathe and shaft.
You start with loosening the set screw on the hand wheel and the screw that weavy washer next, loosen the pulley setscrew and then drive the shaft out.
RE: 46 460 lathe bearing replacement - Leo Vanderloo - 02-07-2021
(02-01-2021, 08:12 PM)Bill Mains Wrote: Anybody?
Looked on you tube n othe sites n came up empty handed.
Looks pretty easy to me, I have the parts layout here, if you take a close look you see how the parts are in and on the lathe and shaft.
You start with loosening the set screw on the hand wheel and then unscrew that, the wavy washer next, then loosen the pulley setscrew and then drive the shaft out, bearings can then be removed.
RE: 46 460 lathe bearing replacement - cbygeorge - 02-14-2021
(01-11-2021, 12:10 PM)Bill Mains Wrote: Any videos or a set of detailed instructions on how to do a bearing change?
Have a look over at OWWM (Old Woodworking Machines). I am sure someone there could help you.
RE: 46 460 lathe bearing replacement - Leo Vanderloo - 02-14-2021
One more time to try to ad the parts layout, that's it, I have it here on my computer but how to upload it ???
I'm not going to upload it to a 3th place and then bring it here, should be no need for that.
[attachment=33268][ ]
RE: 46 460 lathe bearing replacement - clovishound - 02-15-2021
Well, the lack of videos on this replacement MAY mean it is a low failure part.
Not a factor for you, if this is due to a failure vs preventive replacement.
I assume it is very similar procedure to that of the Jet mini. I did one years ago and it was a piece of cake.
RE: 46 460 lathe bearing replacement - EvilTwin - 02-16-2021
(02-14-2021, 07:54 AM)cbygeorge Wrote: Have a look over at OWWM (Old Woodworking Machines). I am sure someone there could help you.
Don't mention that lathe if you do. They limit discussions to non Asian made machinery. The one referenced is probably Taiwanese and verboten.
A few linkys I found:
https://www.woodtalkonline.com/topic/8696-delta-46-460-problems/
https://www.penturners.org/threads/46-460-bearing-blues.113917/
HTH