+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: aligning two drill points (/showthread.php?tid=7361586)
Pages:
1
2
aligning two drill points - Flat Spots - 03-15-2021
What is a two-armed tool called that marks a point on an upper board to line up with a point that has been drilled on a board underneath or that cannot be seen?
Thanks, Dalton
RE: aligning two drill points - Wizard of Oz - 03-15-2021
Do you mean a "transfer punch"?
RE: aligning two drill points - Sqpegs - 03-15-2021
Could be called "dowel centers"
RE: aligning two drill points - fredhargis - 03-16-2021
Since I'm not exactly sure I've got your description correct, would an outside caliper do it? I envision you want to mark the same point on the top and the bottom of a board.
[attachment=34162]
RE: aligning two drill points - Cooler - 03-16-2021
I recently purchased this transfer punch set. It finds the center point for a drilled hole.
https://www.amazon.com/gp/product/B01ADBNEJE/ref=ppx_yo_dt_b_asin_image_o07_s01?ie=UTF8&psc=1
![[Image: B01LWZCVRE-410x500.jpg]](https://superiortoplist.com/wp-content/uploads/2020/03/B01LWZCVRE-410x500.jpg)
RE: aligning two drill points - Willyou - 03-16-2021
Highland Woodworking has a tool called an AccuScribe Pro ?
Or, maybe this ?
RE: aligning two drill points - Sqpegs - 03-16-2021
https://www.rockler.com/dowel-centers-individual-sizes
I posted earlier, but bid not have a link. The link above is to dowel centers
RE: aligning two drill points - Cooler - 03-17-2021
(03-16-2021, 10:29 AM)Sqpegs Wrote: https://www.rockler.com/dowel-centers-individual-sizesDowel centers work basically the same as the punches I referenced in post #12. They are generally only available in common dowel sizes, and are very inexpensive.
I posted earlier, but bid not have a link. The link above is to dowel centers
I use the center finding punches this way:
I make a template from masonite, marking all the locations for cuts, holes, etc. with a prick punch. I then drill out those marked positions with a 1/4" or 3/8" drill bit.
I then place the template over the plywood and using the appropriate size punch I mark the centers for all the data points.
At that point it is just "connect the dots" or drill out the holes.
RE: aligning two drill points - Alan S - 03-22-2021
From what the OP said, I think he's asking about the jigs used to make sure a hole intersects with another deep hole crosswise, as for locating a nut for a bed bolt. While I don't have a name, here's a link to such a jig: https://www.finewoodworking.com/2012/11/20/two-techniques-for-bed-bolt-alignment
RE: aligning two drill points - Willyou - 03-22-2021
I think that Flat Spots has abandoned us.