Started Christmas gifts - Printable Version +- Woodnet Forums (https://forums.woodnet.net) +-- Thread: Started Christmas gifts (/showthread.php?tid=7365940) |
Started Christmas gifts - gear jammer - 11-09-2021 I bought some key ring kits, the bushings and some blanks for making Xmas gifts. The stars and stripe kits from PSI are brittle. I get about half way down and they shatter. I raised my tool rest and lowered my handle to make sure the bevel was in play. I got farther using my old carbide tools than my good stuff. Any suggestions would be appreciated. Thanks. RE: Started Christmas gifts - crokett™ - 11-11-2021 Make sure the blank is well-glued to the tube. If you are using carbide tipped tools, raise the handle and lower the tip so that it is cutting at or just below the centerline on the blank. there is much less of a chance of shattering anything. I have a large tool that has a cutter that's about 1/2" wide. I will sometimes roll it to an angle to produce more of a shearing cut for something tricky. You know you are doing it right with acrylic or polycrylic if the cutting comes off in a continuous ribbon. When I'm on my game I can turn a blank almost completely and it's that continuous ribbon. RE: Started Christmas gifts - crokett™ - 11-11-2021 Also depending on how good you are with one, a skew or straight chisel will help. I am ok with one, not great especially on small stuff. RE: Started Christmas gifts - Arlin Eastman - 11-11-2021 Not all of their blanks are that bad but some are. Me all I do it turn up the rpm and take my sharp detail gouge and small bits until it is round. You can also take the blank to a belt sander to round off the corners abit but I have never had to do it yet. It all depends on how you use the tool to the blank. I go from the side and go inward to knock off the corners and then sharpen the gouge again and finish it off with just a bit left to sand to the desired thickness which goes fast RE: Started Christmas gifts - happycamper000 - 12-28-2021 girl friend requested a new spanking paddle made of wood so i could spank her back side when she is bad New user, perhaps a spammer, who's posts are being moderated. |