+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Delta Junior (/showthread.php?tid=7366091)
Delta Junior - tablesawtom - 11-18-2021
Is a Delta Junior a 8 inch table saw or a 9 inch?
Tom
RE: Delta Junior - fredhargis - 11-18-2021
Going from memory, it's an 8" saw.
RE: Delta Junior - tablesawtom - 11-18-2021
(11-18-2021, 03:05 PM)fredhargis Wrote: Going from memory, it's an 8" saw.
I am thinking the same thing but just wanted to check, man the motor is something else on it.
Tom
RE: Delta Junior - med-one - 11-19-2021
It takes a 8" blade for sure.
RE: Delta Junior - Tony Z - 11-19-2021
Is that the Delta machine that had the motor hanging off the back, with the shaft going through, able to run a jointer or drill press also?
RE: Delta Junior - tablesawtom - 11-20-2021
(11-19-2021, 11:16 AM)Tony Z Wrote: Is that the Delta machine that had the motor hanging off the back, with the shaft going through, able to run a jointer or drill press also?
No, it looks like an undersized UNI saw. I am tiring to decide to restore it or to part it out.
Tom
RE: Delta Junior - Tony Z - 11-20-2021
(11-20-2021, 10:05 AM)tablesawtom Wrote: No, it looks like an undersized UNI saw. I am tiring to decide to restore it or to part it out.
Tom
Thanks Tom. I have one of the types I described (I think I have it!), loaned to my brother in 1996. I have not seen it since. Tablesaw was just OK, but the 4” jointer was sweet!