+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: L-N workbench question (/showthread.php?tid=7366282)
L-N workbench question - Aram - 11-30-2021
Question about Lie-Nielsen workbench. Recent move, I told movers not to life it by the vises, but I think they did. The vises are still flush with the top and tighten up solid, but when the jaws are open, they both wobble if I try to move them. I don't remember if they had slop or not before the move. Is that normal?
Thanks.
RE: L-N workbench question - Philip1231 - 12-01-2021
On page 12 of the LN installation instructions, they show you how to eliminate play in the end vise. Still thinking about what could have happened to front vise: that is very securely attached to bench. To answer your question, the front vise has no slop, and the tail vise should have no slop, assuming those set screws are adjusted correctly.
LN Vise Installation Instructions
RE: L-N workbench question - Mike Brady - 12-01-2021
I can't speak to the end vise as I don't have one; but, the front vise (18" twin-screw) does seem to require some adjustment seasonally to keep the chop perfectly parallel to the bench top. I just loosen and adjust the jam nut as needed. When I moved my bench a couple of years ago, I took the vises
off and disassembled the legs. The only part that needed a two-man lift was the top. I have a feeling that there are some nice benches out there that won't see a new home because they are assembled with with permanenet joinery or are just too big to move out of a basement.... Like building a boat in a basement.
RE: L-N workbench question - Aram - 12-02-2021
(12-01-2021, 08:03 AM)Philip1231 Wrote: On page 12 of the LN installation instructions, they show you how to eliminate play in the end vise. Still thinking about what could have happened to front vise: that is very securely attached to bench. To answer your question, the front vise has no slop, and the tail vise should have no slop, assuming those set screws are adjusted correctly.
LN Vise Installation Instructions
Thank you! I had not known about the set screws, designed specifically for eliminating slop. That was an easy adjustment.
I'm not sure why the face vise wiggles a little when it is open. But it's not much, and probably not worth worrying about. I think.