+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Punch Saw For Plaster Wall? (/showthread.php?tid=7368186)
Punch Saw For Plaster Wall? - David Stone - 03-14-2022
Will a punch saw cut through plaster and lath for a new receptacle ? I don’t have a grinder and would rather not buy one. Or deal with the dust.
Thanks in advance.
RE: Punch Saw For Plaster Wall? - woodworker501 - 03-14-2022
You need one with a real stiff blade. Shark is a good one.
RE: Punch Saw For Plaster Wall? - blackhat - 03-14-2022
Is it metal or wood lath?
RE: Punch Saw For Plaster Wall? - lift mechanic - 03-14-2022
Drill a 1/2" hole and use a jig saw to make the cut.
RE: Punch Saw For Plaster Wall? - Roly - 03-15-2022
(03-14-2022, 07:01 AM)David Stone Wrote: Will a punch saw cut through plaster and lath for a new receptacle ? I don’t have a grinder and would rather not buy one. Or deal with the dust.
Thanks in advance.
What are you calling a punch saw ? The type you hit with your hand for drywall or a saws-all type. With the hand type you would need to drill a hole to get started without breaking the plaster and most have coarse teeth. Roly
RE: Punch Saw For Plaster Wall? - Bob10 - 03-16-2022
(03-14-2022, 07:01 AM)David Stone Wrote: Will a punch saw cut through plaster and lath for a new receptacle ? I don’t have a grinder and would rather not buy one. Or deal with the dust.
Thanks in advance.
I would use something with a less aggressive blade so you don't loosen up or crack plaster you plan on keeping. If you have a multitool or rotozip you might be better off using either of those
RE: Punch Saw For Plaster Wall? - srv52761 - 03-16-2022
(03-16-2022, 01:00 AM)Bob10 Wrote: I would use something with a less aggressive blade so you don't loosen up or crack plaster you plan on keeping. If you have a multitool or rotozip you might be better off using either of those
I think this is the winner. Any tool with a reciprocating blade risks vibrating the lath and causing more plaster to break out than intended. My first house was lath and plaster and I learned right away to use a fine tooth hacksaw blade on the pull stroke. Now a days a rotary tool with a cutting wheel would be my first choice.
RE: Punch Saw For Plaster Wall? - EdL - 03-16-2022
First l would use a hole saw (as large as practical) to open up the wall.
Then get the Milwaukee handle that takes a sawzall blade. Pick a fine blade and start cutting to size. As said, smaller teeth to prevent plaster damage.
You'll find the handle to be nice to have in the long run, trimming trees etc, they even make a knife blade kit for it and one can screw a paint roller extension handle in the end.
The Milwaukee quik loc grabs the blade rock solid, no worries.
Ed