+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Craftsman 113 Question (/showthread.php?tid=7368314)
Craftsman 113 Question - 1BigTime - 03-23-2022
I have a Craftsman 113.298240. I was trying to set a depth for a cut yesterday. I set it at 3/8", but when I turned the saw on and made the cut, it went to about 1/2". I lowered it, and after that it held, but it did it several times after that. Any help on why that is occuring?
RE: Craftsman 113 Question - Roly - 03-23-2022
(03-23-2022, 10:01 AM)1BigTime Wrote: I have a Craftsman 113.298240. I was trying to set a depth for a cut yesterday. I set it at 3/8", but when I turned the saw on and made the cut, it went to about 1/2". I lowered it, and after that it held, but it did it several times after that. Any help on why that is occuring?
Are you locking the elevation lock after adjusting ? Roly I don't see a lock on that saw. If you are cranking up to set the blade height try cranking down to set the height as this would take the gear slop out.