+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Tool ID? (/showthread.php?tid=7369530)
Pages:
1
2
Tool ID? - MT Woodworker - 06-13-2022
Hi
Any thoughts on the use of these tools?
Scale for size reference.
Thanks
[attachment=42781]
[attachment=42782]
RE: Tool ID? - andrewb - 06-13-2022
(06-13-2022, 01:07 PM)MT Woodworker Wrote: Hi
Any thoughts on the use of these tools?
Scale for size reference.
Thanks
Bottom two are what I'd call a Cape chisel. For metal work, useful to have if the need arises. Sort of used the same way that a woodworking chisel would be but for metal. The bottom one looks like edge is either very dull or reground and is realistically just a cold chisel now. Top one i can't tell - maybe a bearing scraper?
Andrew
RE: Tool ID? - Timberwolf - 06-14-2022
(06-13-2022, 01:47 PM)andrewb Wrote: Bottom two are what I'd call a Cape chisel. For metal work, useful to have if the need arises. Sort of used the same way that a woodworking chisel would be but for metal. The bottom one looks like edge is either very dull or reground and is realistically just a cold chisel now. Top one i can't tell - maybe a bearing scraper?..........................
Andrew
They are cape chisels..I have had a couple for many years..seldon had a use for them..
RE: Tool ID? - MT Woodworker - 06-14-2022
Thanks for the answers. They were my grandfather’s tools.
Mark
RE: Tool ID? - Bucko - 06-15-2022
1980 found me as a Pipefitter Apprentice and bottom ones look like Gouge Chisels we had to remove broken pieces of threaded male pipe broken off / stuck in female fittings .
RE: Tool ID? - bandit571 - 06-20-2022
A Cape chisel was also used to cut new key-way slots onto steel shafts....
RE: Tool ID? - toolmiser - 06-20-2022
I learned something new again. I have a few "cape chisels" and I never knew what they were for.
RE: Tool ID? - Timberwolf - 06-21-2022
(06-20-2022, 09:05 AM)bandit571 Wrote: A Cape chisel was also used to cut new key-way slots onto steel shafts....
............
A very crude keyway.. but still a keyway....tough to do on a hardened steel shaft.
RE: Tool ID? - bandit571 - 06-21-2022
And, will also clean up any "Boogered up" slots....
RE: Tool ID? - adamcherubini - 06-23-2022
Bottom one is a ruler, but some people call it a scale.
(Sorry guys couldn’t resist)