Speaking of chuck keys... - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Speaking of chuck keys... (/showthread.php?tid=7371840) |
Speaking of chuck keys... - ed kerns - 01-07-2023 Are they standardized? I have a Jacobs chuck on my lathe that needs a key. The one from my drill press fits it sorta, but not perfectly. I bought the lathe and some accessories 2nd hand, so I've never seen the original. I'd buy one of the 'universal' 4-way chucks if I could be sure one of the 4 would fit. Thank you! RE: Speaking of chuck keys... - EdL - 01-07-2023 Not standard. Key size is dependant on chuck size. Check McMaster Carr, they should size the keys by the number on your chuck. Ed RE: Speaking of chuck keys... - ed kerns - 01-07-2023 (01-07-2023, 07:09 PM)EdL Wrote: Not standard. Key size is dependant on chuck size. Thanks for this! I don't know why I didn't think of McMaster Carr. They do indeed sell by matching the number on the chuck. All that aside, you'd like to think they'd narrow it down to a few standard sizes. RE: Speaking of chuck keys... - museumguy - 01-08-2023 If you know the size of the chuck key and haven't ordered one yet, I may have one and can send it to you for free. For some odd reason, over the years I've collected a few chuck keys. RE: Speaking of chuck keys... - Philip1231 - 01-08-2023 You can contact Jacobs Chuck and they will help you determine which key you need for the chuck. Very helpful. RE: Speaking of chuck keys... - Bob Vaughan - 01-09-2023 (01-08-2023, 05:20 PM)Philip1231 Wrote: You can contact Jacobs Chuck and they will help you determine which key you need for the chuck. Very helpful. [attachment=45788] |