+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Cutting Polylac filler (/showthread.php?tid=7372286)
Cutting Polylac filler - RobertNP - 02-18-2023
I have been away from woodworking for a very long time. I have a cabinet filler strip above the refrigerator opening that I need to cut down by 3/8 inch to fit in a taller refrigerator. Can I safely rip the piece down to size on my tablesaw and get a clean cut without damaging the high gloss finish on the front of the filler? Any suggestions would be appreciated.
RE: Cutting Polylac filler - jteneyck - 02-18-2023
(02-18-2023, 12:04 PM)RobertNP Wrote: I have been away from woodworking for a very long time. I have a cabinet filler strip above the refrigerator opening that I need to cut down by 3/8 inch to fit in a taller refrigerator. Can I safely rip the piece down to size on my tablesaw and get a clean cut without damaging the high gloss finish on the front of the filler? Any suggestions would be appreciated.
Sure, use a sharp rip blade and have at it. FWIW, cutting faster is better than slower to keep the blade cool which, in turn, keeps the wood cooler.
John