+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: A Fancy Drill Bit? (/showthread.php?tid=7374410)
A Fancy Drill Bit? - bandit571 - 11-29-2023
While putting away toys..found this in a drawer..
[attachment=48983]
Seems to be a way to open it up and sharpen it?
[attachment=48984]
Just have to figure HOW to sharpen it.....
[attachment=48985]
Before I can place it into a Brace drill.....
RE: A Fancy Drill Bit? - fixtureman - 11-30-2023
It's a counter sink
RE: A Fancy Drill Bit? - bandit571 - 11-30-2023
Soooo....just exactly HOW would you go about sharpening this?
RE: A Fancy Drill Bit? - MarkSingleton - 11-30-2023
I think I would try to chuck it into a power drill and run in reverse on sandpaper, holding it at the right angle of course.
Easier said than done of course. If you have a spare auger chuck, perhaps an adapter of some kind could be made.
RE: A Fancy Drill Bit? - gjohn - 12-01-2023
If you remove the screw can you fit sandpaper glued to a piece of sheet metal between the two halves?
RE: A Fancy Drill Bit? - bandit571 - 12-02-2023
Yep, and..the 2 halves can rotate side to side, as there is a pivot point up at the tapered end.