+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Just hanging around? (/showthread.php?tid=7375718)
Just hanging around? - bandit571 - 04-27-2024
Happened to go to the shop last evening..needed a few photos of..
[attachment=50797]
Seems someone thought these were "Junk"...
While down there, I turned towards the Tool Cabinet...
[attachment=50798]
This is the center of the 2 doors, from the outside...kind of busy?
[attachment=50799]
And most have seen this wide view...details?
[attachment=50800]
Of the door on the left side...just a few ready-to-use saws...look a bit lower..
[attachment=50801]
Canvas roll is a full set of Irwin bits for the Brace drills...there is a square trying to hide....and that Breast Drill is a Goodell Pratt 477. It is more for the round shanked twist drill bits.
Wood shop is out of Lumber, at the moment....might try to go out, today...and correct that Problem..