+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Just another Box Project? (/showthread.php?tid=7377290)
Just another Box Project? - bandit571 - 11-19-2024
Hey, gotta use up the leftovers, some how.....Maybe resaw a stack down to 1/2" thick...glue a few into panels?
IF anyone wants to follow along.....will start this after all the errands for today have been run....
Stay tuned...
RE: Just another Box Project? - professore - 11-20-2024
I'll be following.
Frank S in IA
RE: Just another Box Project? - MarkSingleton - 11-20-2024
Yup. Me too!!
RE: Just another Box Project? - stav - 11-20-2024
Did you pick up a new tool you need to share that needs a box? Should be interesting.
RE: Just another Box Project? - bandit571 - 11-20-2024
Resaws were done on the tablesaw...stuff that wasn't usable, was tossed. Trying to keep the better looking stuff...like these...
[attachment=53053]
Goal was to find enough pieces that I could match up..
[attachment=53054]
Some better than others..
[attachment=53055]
And try for 4 panels glued up....
[attachment=53056]
#4 was sitting over on the bench...Panels are 1/2" thick Ash.
Let these sit a day or 2...Middle one of those 3 was to be the "Lid"....Turned out, that I needed a 3 strip glued to it..
[attachment=53057]
Still have not removed THOSE clamps, yet...will wait until I start Lid Work...
To help things out, panels were rip to 6" wide...as that is all the wider the vise will open..
[attachment=53058]
This is Panel #4, the "Back" of the case....needed planed flat and smooth..
[attachment=53059]
A #3 seemed to work just fine....other planes in use?
[attachment=53060]
A #4-1/2 and a #6c.mainly to joint an edge or 2 before a glue up...
There was one board that wasn't a glue-up, though..
[attachment=53061]
Just needed smoothed down a bit.....Case has 2 drawers, and an upper compartment.....and this is the front of that compartment...
[attachment=53062]
Stay tuned...corner joints will be through dovetails..LOTS of Through Dovetails...