+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Baseboard installation help (/showthread.php?tid=7377487)
Baseboard installation help - DaveParkis - 12-17-2024
I am remodeling my kitchen and the flooring guys removed the baseboard to install the new floor. I need to reinstall the baseboard and can't figure out how to nail behind the cast iron radiator. Any suggestions?
RE: Baseboard installation help - Woodenfish - 12-18-2024
If you are able to get a long driver bit and a narrow head trim screw back there I don’t think anybody would ever know.
RE: Baseboard installation help - EatenByLimestone - 12-18-2024
Would construction adhesive work?
RE: Baseboard installation help - stav - 12-18-2024
Would a pin punch get you to where you need to be? I'd put some double sided tape on it and stick the nail to it, then feed through the radiator and then hammer it in. Probably not the most elegant solution but it should allow you to get that nail in there. Or use a screw with a long driver.
RE: Baseboard installation help - joe1086 - 12-18-2024
(Today, 01:28 AM)Woodenfish Wrote: If you are able to get a long driver bit and a narrow head trim screw back there I don’t think anybody would ever know.
That's what I'd do.
RE: Baseboard installation help - blackhat - 12-18-2024
If it’s nailed at each end of the rad is it going to fall off? If it’s not really tight will anyone be able to see it?
RE: Baseboard installation help - tomsteve - 12-18-2024
(Yesterday, 11:48 PM)DaveParkis Wrote: I am remodeling my kitchen and the flooring guys removed the baseboard to install the new floor. I need to reinstall the baseboard and can't figure out how to nail behind the cast iron radiator. Any suggestions?
was it nailed back there before?