Reverse of a Birds mouth router bit?

Reverse of a Birds mouth router bit? - Printable Version

+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Reverse of a Birds mouth router bit? (/showthread.php?tid=7377559)

Reverse of a Birds mouth router bit? - JDuke - 12-27-2024

Id like to streamline the cutting of a 90 degree angle on the edge of a board that is off axis enough to use it as a flat piece of crown molding

[attachment=53375]

I know I could do something like this with 4 cuts on the table saw, but I’d like a router bit that would cut each side in one pass.

I am sure a bit like this exists, what name does it go by so I can search for it?

Thanks
Duke

RE: Reverse of a Birds mouth router bit? - Roly - 12-27-2024

(Yesterday, 11:15 AM)JDuke Wrote: Id like to streamline the cutting of a 90 degree angle on the edge of a board that is off axis enough to use it as a flat piece of crown molding

I know I could do something like this with 4 cuts on the table saw, but I’d like a router bit that would cut each side in one pass.

I am sure a bit like this exists, what name does it go by so I can search for it?

Thanks
Duke

Crown bevel bit, Freud #99-421. This is a large bit not for hand held router use, Not cheap. Roly
Freud bit scroll down page

RE: Reverse of a Birds mouth router bit? - jteneyck - 12-27-2024

Grizzly calls it a 90 degree V-groove bit:

Link

John

RE: Reverse of a Birds mouth router bit? - JDuke - 12-27-2024

Thank you both,

I knew the profile existed but kept coming up empty using the wrong search terms.