+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Melamine for workbench top (/showthread.php?tid=7378186)
Melamine for workbench top - Randy C - 03-20-2025
As stated in earlier post I’m building a corner workbench in my shop which will see light duty use. Does anyone have any experience with melamine? Was thinking about using 3/4 MDF as base and was wondering if a sheet of 3/4 Melamine on top of the MDF would be a good option. Other option is 2 layers of MDF covered by 1/4 hardboard.
Thanks
RE: Melamine for workbench top - museumguy - 03-20-2025
Go with the hardboard. melamine is a very thin coating. It is not very durable, especially for a workbench top. Attach the hardboard so that it is removable. When it wears out, replace it.
RE: Melamine for workbench top - Allen - 03-20-2025
I use Melamine for the top of my assembly table. Main reason is I can take a razor scrapper and remove glue squeeze out, paint drops, varnish and so on from the top easily.
It has held up well for several years and I made it so it can be replaced if need be. I would not recommend it for a general workbench top where you would be dragging metal across the surface or pounding on stuff with a hammer.
Al
RE: Melamine for workbench top - R Clark - 03-21-2025
I agree with the others regarding melamine. I have used it a couple times; not my material of choice.
The main work table (48" x 48") in my shop is a double layer of 3/4" particle board covered on top with plastic laminate (aka Formica). It doubles as the outfeed table for my cabinet saw. It's much more durable than melamine. It does stain over time, but it's a work bench, not a dining room table.
The cabinet counter tops in my shop are 1/4" hardboard over particle board. The thing I like about that setup is that I occasionally screw things temporarily into place for specific reasons and then remove them. I also don't worry about cuts and nicks in that hardboard. If that hardboard gets too beat up, then it's fast, easy, and cheap to replace.