Search Results
|
Post |
Author |
Forum |
Replies |
Views |
Posted
[asc]
|
|
|
Thread: Door Size for Blum 155 No Protrusion?
Post: RE: Door Size for Blum 155 No Protrusion?
Stwood_ Wrote: (01-02-2024, 10:06 PM)
--
Inset doors? Yes.
--
I have a 2016 catalog from woodworkershardware.com Data should still be good. The "155" is shown with overlay doors only. People th... |
|
NormT |
Woodworking
|
4 |
399 |
01-04-2024, 11:14 AM |
|
|
Thread: What am I doing wrong. SharkBite threaded connector
Post: RE: What am I doing wrong. SharkBite threaded conn...
stav Wrote: (03-10-2021, 10:07 AM)
--
The feed pipe is pex. The threaded parts are all brass.
--
I think the problem is a hose bib is a different thread than the tapered iron nipple installed in th... |
|
NormT |
Home Improvement
|
18 |
4,552 |
03-10-2021, 11:48 AM |
|
|
Thread: Anyone here have bun beds?
Post: RE: Anyone here have bun beds?
BloomingtonMike Wrote: (06-29-2018, 03:17 PM)
--
Bunk beds have box springs?
--
When buying a mattress recently I asked why a box spring was used. The answer was, the box spring insures a flat s... |
|
NormT |
Woodworking
|
10 |
6,538 |
06-30-2018, 02:36 PM |
|
|
Thread: Delta Unisaw Newest design
Post: RE: Delta Unisaw Newest design
What am I missing here? No one mentions Jet.
I have a Jet cabinet saw, will have used it for one week less 16 years. I was set-up spot on out of the crate, replaced the motor start switch once. Ot... |
|
NormT |
Woodworking Power Tools
|
25 |
17,176 |
03-18-2017, 10:04 AM |
|
|
Thread: ripping oak posts
Post: RE: ripping oak posts
I think there are others on this forum from MN that could help you with this. If all else fails, I would be happy to help. I have a 14" Jet bandsaw and a jointer. I am about 60 miles south of you,... |
|
NormT |
Woodworking Power Tools
|
14 |
8,159 |
03-18-2017, 09:56 AM |
|
|
Thread: DW-735 Knife Bevel Angle
Post: RE: DW-735 Knife Bevel Angle
Brain,
I have a new set of these knives. Don't have the best measuring device and old eyes but looks like 42 degrees, no secondary bevel.
Send some warm weather this way! This is bad even for Minne... |
|
NormT |
Woodworking Power Tools
|
2 |
2,328 |
12-17-2016, 10:22 AM |
|
|
Thread: Carbide Blades sharpening service?
Post: RE: Carbide Blades sharpening service?
Reb,
I was going to suggest Rockler. Also Eide Saw, 950 13th Ave NE , Minneapolis and Acme Tool. Never used any of them.
If you live south of the Cities, Clelands Clean Cut, 944 SW 6th Ave, Fariba... |
|
NormT |
Woodworking
|
51 |
38,991 |
12-04-2016, 12:22 PM |