Posts: 2,605
Threads: 0
Joined: Jan 2004
What is the best way to shorten a 26" saw blade to 20"?
Cheers ...
Lyn Disbrow: Born in America ... a long long time ago
Posts: 10,099
Threads: 0
Joined: Nov 2011
Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
Dremel tool with cutoff wheel?
Thanks, Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard
Posts: 13,416
Threads: 4
Joined: Jun 2007
Location: New Jersey
I've done a few where the toe was too thin for use. Score it with a cutoff wheel, you don't have to go all the way thru, halfway is good enough. Then put it in a vice and snap it off. If you don't have a wheel, I guess you could score it with a file too. Cleanup the edge with a file.
Credo Elvem ipsum etiam vivere
Non impediti ratione cogitationis
Posts: 10,726
Threads: 1
Joined: Jan 2006
Location: Orlando, Florida
Admiral said:
I've done a few where the toe was too thin for use. Score it with a cutoff wheel, you don't have to go all the way thru, halfway is good enough. Then put it in a vice and snap it off. If you don't have a wheel, I guess you could score it with a file too. Cleanup the edge with a file.
Put the keeper part in the vise. The throwaway part above the vise. Otherwise you risk bending the plate. You can clean up the break by grinding. Just keep the blade cool. You will lose a bit of the taper when you take off the last 6 inches, so it might be a tad harder to start, because the kerf will be wider at the toe vs. a full length saw. That's assuming it's taper ground.
Still Learning,
Allan Hill
Posts: 833
Threads: 0
Joined: Nov 2006
First and foremost don't shorten a saw unless years of sharpening has made the blade too narrow in the tip.
I hate when people chop off the tips of perfectly good 26 or 28 inch handsaw to get a very clumsy panel saw substitute. Those long handsaws only exist in a limited number on the market and for every one that is destroyed there will be one less left for us who need them.
Part timer living on the western coast of Finland. Not a native speaker of English
Posts: 13,416
Threads: 4
Joined: Jun 2007
Location: New Jersey
AHill said:
Put the keeper part in the vise. The throwaway part above the vise. Otherwise you risk bending the plate.
Yes, forgot to mention that, very important.
Credo Elvem ipsum etiam vivere
Non impediti ratione cogitationis
Posts: 243
Threads: 0
Joined: Jan 2009
I use a big tin snips and shear them off, then file off the burr.
Posts: 10,726
Threads: 1
Joined: Jan 2006
Location: Orlando, Florida
TGW said:
First and foremost don't shorten a saw unless years of sharpening has made the blade too narrow in the tip.
I hate when people chop off the tips of perfectly good 26 or 28 inch handsaw to get a very clumsy panel saw substitute. Those long handsaws only exist in a limited number on the market and for every one that is destroyed there will be one less left for us who need them.
In my case, I shortened one because the tip was irreparably bent/kinked. I ended up saving a saw that would otherwise be relegated to the rust heap.
Still Learning,
Allan Hill
