Posts: 21,259
Threads: 2
Joined: Mar 2009
Location: IA
"I posted this in the Tuning forum but it was suggested to ask here too."
to put handles on a few knives I have.
So what kind of rivets do you use and where do you buy them?
Also a link Please.
Arlin
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification. Thank You Everyone.
It is always the right time, to do the right thing.
Posts: 3,017
Threads: 1
Joined: Aug 2009
Check at your local hardware store. Mine has copper and brass. The copper ones are technically "roves," used in wooden boatbuilding.
Posts: 701
Threads: 0
Joined: Aug 2007
Location: Vancouver Island, B.C. -eh!
Posts: 21,259
Threads: 2
Joined: Mar 2009
Location: IA
Thanks Bill
Jim
I think those will work the best.
Thank you
Arlin
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification. Thank You Everyone.
It is always the right time, to do the right thing.
Posts: 887
Threads: 0
Joined: Sep 2009
Location: Carlisle, PA
For my money and for quality sake, I always check out
McMaster first and then go from there.
Posts: 1,474
Threads: 0
Joined: Mar 2011
Go here.
http://www.knifemaking.com They will have what you need, specifically for knives.
Jim
Posts: 314
Threads: 0
Joined: Feb 2012
Location: Carson Valley, NV
I recently restored an antique cedar chest and needed copper tacks. I was unable to find any locally.
I found Van Dyke's and ordered from them. They have quite an extensive list. Their prices, shipping and service was very good.
http://www.vandykes.com.
