Posts: 511
Threads: 0
Joined: Jun 2010
I have a plastic xmas ornament ball, 2" in diameter and need to glue a threaded rod inside the ball. I would simply like to fill the ball with some kind of glue or adhesive and insert the rod and let it harden up, simple project. However there is NO air exchange inside the ball, so what glue/adhesive could I use? The opening for the threaded rod is 1/8" so the adhesive needs to be liquid form. Simple project if I can find the right glue.
Posts: 21,878
Threads: 0
Joined: Oct 2003
Can you glue a small curved washer to the rod and glue it to the surface of the ornament at the opening?
Easy and done.
Gary
Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.
Posts: 1,189
Threads: 0
Joined: Jun 2003
Location: Wakefield, MA
Epoxy should do the trick.
Posts: 12,876
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
Polyester boat resin. Bondo would work, too, if you can force it through the hole - quickly because it hardens fast.
John
Posts: 1,289
Threads: 0
Joined: Sep 2012
Location: Mobile, Alabama
If the finished ball only needs to hold it's own weight, how about using some of the aerosol foam insulation. There is a kind that doesn't expand very much. You might put some kinks or bends in the threaded rod to help it stay put. I'm guessing that you don't want the finished ball to have a lot of weight.
Posts: 4,646
Threads: 0
Joined: Jan 2008
keep it simple. scuff up the rod, get some epoxy and put it in a bowl of warm water to heat it up and make it pour easier, mix it up, pour in hole, insert rod, let cure.
