Woodnet Forums › › Active › Finishing v
Earlex HVLP 5500
Thread Modes
Earlex HVLP 5500
Bill Holt Offline
Member
Posts: 2,387
Threads: 0
Joined: Jan 2008
Location: Irving, Tx
#4
07-07-2016, 03:49 PM
I have owned it for 10+ years and never had a problem until yesterday. The pattern was like this ** ** The gun was absolutely clean when I started. What do you think caused the void in the pattern? I was using water base Kilz. I put on over lapping passes vertical and horizontal, to my surprise coverage was nice.

Today I did two coats of the finish paint and there was no problem. Is it reasonable to think I was putting on too little primer?

I look forward to the WN wisdom.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Find
Reply
Rob Young Offline
Helper Monkey
Posts: 4,133
Threads: 0
Joined: Oct 2009
Location: Lawrence, KS
#5
07-07-2016, 07:39 PM
A figure 8 pattern, material at the ends and little to nothing in the middle, is an air cap issue. Clean out the orifice s and channels in the cap. And if there is a diverter behind the cap that to should be cleaned.

Solvent, brushes, toothpicks, little wires used for cleaning wire welders, etc.
Don't sweat the petty things and don't pet the sweaty things. -- G. Carlin
Find
Reply
Bill Holt Offline
Member
Posts: 2,387
Threads: 0
Joined: Jan 2008
Location: Irving, Tx
#6
07-08-2016, 08:50 AM
Thank you Rob.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.