Posts: 2,273
Threads: 3
Joined: Feb 2005
Location: Central America
I want to make a shooting board. Should the rabbet that the plane rides on only be as shallow as necessary? I was thinking if it was too low, the blade would be planing away the platform on which the board you're trimming rests on or maybe it's supposed to.
Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
That will happen for the 1st few strokes, then the plane's sole will prevent further cutting.
Thanks, Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard
Posts: 4,133
Threads: 0
Joined: Oct 2009
Location: Lawrence, KS
(02-04-2017, 02:54 PM)atgcpaul Wrote: I want to make a shooting board. Should the rabbet that the plane rides on only be as shallow as necessary? I was thinking if it was too low, the blade would be planing away the platform on which the board you're trimming rests on or maybe it's supposed to.
Shallow enough that you aren't giving up a bunch of the blade width but deep enough that the side of the mouth is hurried and so limits depth of cut.
Don't sweat the petty things and don't pet the sweaty things. -- G. Carlin
Posts: 1,150
Threads: 0
Joined: Nov 2006
Location: Texas - Gods Country
The plane will cut the rabbet the first time you use it. just glue 3 boards together and get after it.
Don't over complicate your first one.
Posts: 87
Threads: 0
Joined: Dec 2006
If you consider the sole of the plane, you will see that it is only the 1/4 inch or slightly less, at the edge, which guides the plane.
3/4 inch base board and runway may be a convenient option.
David
Posts: 2,774
Threads: 0
Joined: Oct 2012
Location: W. of Rainier, E. of Orcas
02-06-2017, 03:26 PM
(This post was last modified: 02-06-2017, 03:27 PM by hbmcc.)
If you like really simple, and have a bottle of old CA glue, just glue a board and a second at the angle you need directly onto the bench. When done smack 'em and scrape off the residue. Simple. Easy. Fast.
Note: This does not work on Melamine surfaces. And, is easy only if you have scraps you won't salvage for smaller projects.
