How much for a larger motor and VFD/Inverter? Cost? Advantage over new?
|
How much for a larger motor and VFD/Inverter? Cost? Advantage over new?
|
05-12-2017, 02:11 PM
I agree with MM. I would stick with your current motor and install a jack shaft and another set of pulleys, or install a Reeves type drive. Either approach should be able to cut your speed by 5 - 10X and your torque will increase. And you will need it for turning large diameter stuff. I'm not sure but I think the required torque goes up with the square of the radius.
John
05-12-2017, 05:05 PM
Okay, you guys aren't going to believe what happened today. An opportunity jumped in my lap and I dove in. Old arn for almost nothing.
More later, probably in the WoodTurning Forum. I'll bug you guys up here for specifics after I get all the info gathered. THANKS!!!!! Your input was invaluable in my decision making.
" The founding fathers weren't trying to protect citizens' rights to have an interesting hobby." I Learn Each Day 1/18/13
www.RUSTHUNTER.com
05-12-2017, 06:03 PM
" The founding fathers weren't trying to protect citizens' rights to have an interesting hobby." I Learn Each Day 1/18/13
www.RUSTHUNTER.com 
05-13-2017, 06:08 AM
That is awesome, congrats!
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
|
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
