Woodnet Forums › › Active › Home Improvement v
Looking for electrical advice
Thread Modes
Looking for electrical advice
MstrCarpenter Offline
Member
Posts: 1,969
Threads: 0
Joined: Feb 2008
#4
11-01-2017, 07:30 PM
I am considering purchasing a 1/2 HP submersible pump that runs on 220v, 50 HZ. This pump is variable speed in that it is supposed to increase/decrease its output depending on demand. My question is related to the 50HZ called for vs. the 60HZ I have available. I'm not looking to purchase another piece of equipment to change 60HZ to 50HZ as that will make the good price not quite so good anymore. As I see it, I will never need the 13+ gallons per minute it is capable of; so it may never run at the now 20% faster R.P.M.s. Not too worried about heat either; it will be fully submersed.
Sign at N.E. Vocational School Cabinetmaking Shop 1976, "Free knowledge given daily... Bring your own container"
Find
Reply
Phil Thien Offline
Member
Posts: 18,906
Threads: 0
Joined: Jul 2006
Location: Milwaukee area
#5
11-01-2017, 08:07 PM
How is the speed actually controlled?  That is, how does it know demand? 

Have a link?
Find
Reply
MstrCarpenter Offline
Member
Posts: 1,969
Threads: 0
Joined: Feb 2008
#6
11-01-2017, 08:18 PM
(11-01-2017, 08:07 PM)Phil Thien Wrote: How is the speed actually controlled?  That is, how does it know demand? 

Have a link?

Hi Phil, The speed was controlled by a processor attached (ithink) to an inline type pressure switch. Anyway I re-opened the link and they were sold out, tried again and it disappeared. Too slow I guess.
Sign at N.E. Vocational School Cabinetmaking Shop 1976, "Free knowledge given daily... Bring your own container"
Find
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.