03-20-2018, 12:55 PM
My bench is 3' x 8'. I have a tool tray with a power source in it 6" from the front & it's 3 1/2"w. A tail vice on the left end. I'm thinking about inlaying a 4' piece of t-track starting about 12" from the vice. Rockler t-track to be exact.
#1-- Will I be happy with one 4' section or should I get an intersection & maybe an extra 24" section?
#2-- Should I be considering starting the track closer to the vice?
#3-- Main use will be clamping face frames for screw assembly & for hold downs for routing/drilling/cutting operations.
Any and all comments & questions are encouraged & appreciated. All ideas will be greatly appreciated!!
Thank You!!
http://www.rockler.com/17-piece-universal-t-track-kit
#1-- Will I be happy with one 4' section or should I get an intersection & maybe an extra 24" section?
#2-- Should I be considering starting the track closer to the vice?
#3-- Main use will be clamping face frames for screw assembly & for hold downs for routing/drilling/cutting operations.
Any and all comments & questions are encouraged & appreciated. All ideas will be greatly appreciated!!
Thank You!!
http://www.rockler.com/17-piece-universal-t-track-kit