Woodnet Forums › › Active › Woodworking v
folley belsaw planer
Thread Modes
folley belsaw planer
wing nut Offline
Member
Posts: 3,130
Threads: 0
Joined: Apr 2005
#5
02-16-2019, 11:20 AM
Has any one ever replace the feed rollers on a folley belsaw planer I have the 9103, if so what are the steps
thanks
Find
Reply
Stwood_ Offline
Member
Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
#6
02-16-2019, 11:37 AM
Been a long time, don't remember the steps but it was fairly easy.
Put some new springs in there while yer at it.

Those like to accumulate gunk and wood chips under the roller attachment area (brass block). Need to keep that area cleaned out, or you'll loose some feed roller pressure.
Steve

Mo.


I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24


 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Find
Reply
DFJarvie Offline
Member
Posts: 588
Threads: 0
Joined: Nov 2010
#7
02-16-2019, 06:01 PM
Some of the gears may need to come off. Before you remove anything take pictures of the planet together and as you take each piece off. This way you have a reference when you put it back together.

I tore mine down and replaced the cutterhead bearings, painted it and cleaned it. Its loud but works great.
Don
Find
Reply
Bob Vaughan Offline
Member
Posts: 1,385
Threads: 0
Joined: Sep 2007
#8
02-16-2019, 09:52 PM
Try these threads.

http://www.owwm.org/viewtopic.php?f=1&t=143202


http://www.owwm.org/viewtopic.php?f=1&t=...w&start=15
Find
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.