Vintage motor disassembly help
#13
You will have to pull the splitter. The penny I mentioned is to protect the threads on the shaft from damage by the puller screw.
Blackhat

Bad experiences come from poor decisions. So do good stories. 


Reply
#14
You might consider investing in a set like this. This is a Harbor Freight version. I overhauled and changed out hundreds of bearings while on a sub-tender in the Navy and a heavy duty set similar to this was our go to tool.

Al
Bearing Separator and Puller Set (harborfreight.com)
Some people are like a Slinky. Not really good for anything but still bring a smile to your face when you push them down a flight of stairs.

A dead enemy is a peaceful enemy. Blessed are the peacemakers.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.