07-28-2015, 03:41 PM
Cutting mortises in leg blanks with HCM. Just replaced the roll pin last week. Must have been a little aggressive driving it in
"honey I need a new tool"
Ended up having to hand cut the last 2.
Got 2 legs cut out before quiting for the day though
I really have to thank ruffcut for sending me the pattern for the legs!
"honey I need a new tool"
Ended up having to hand cut the last 2.
Got 2 legs cut out before quiting for the day though
I really have to thank ruffcut for sending me the pattern for the legs!