Woodnet Forums › › Active › Woodworking Hand Tools v
camber roller necessary for LV honing jig?
Thread Modes
camber roller necessary for LV honing jig?
overland Offline
Member
Posts: 951
Threads: 0
Joined: Mar 2007
#5
03-01-2016, 10:12 AM
If I'm putting a slight camber on a smoother or try plane, do I need the camber roller that is an accessory for the Veritas MK II honing jig? Or can I do it with the straight roller just by putting more pressure on the corners? Anybody have experience with this jig?
Find
Reply
AHill Offline
Honored Veteran
Posts: 10,717
Threads: 1
Joined: Jan 2006
Location: Orlando, Florida
#6
03-01-2016, 10:18 AM
How much camber is "slight"? If you are just wanting enough camber to eliminate the blade tracks, then all you need is additional pressure on each side when honing. No camber roller necessary.
Still Learning,

Allan Hill
Find
Reply
JimBelair Offline
Member
Posts: 701
Threads: 0
Joined: Aug 2007
Location: Vancouver Island, B.C. -eh!
#7
03-01-2016, 11:08 AM
If I want to establish a bit more camber I'll run a 1 cm wide strip of black electrical tape around the middle of the straight roller. This provides a bit of rocker.
Find
Reply
AgGEM Offline
Moving to front of line
Posts: 5,661
Threads: 1
Joined: Mar 2008
Location: Flemington, New Jersey
#8
03-01-2016, 12:51 PM
JimBelair said:


If I want to establish a bit more camber I'll run a 1 cm wide strip of black electrical tape around the middle of the straight roller. This provides a bit of rocker.



Richard Leon had a YouTube video of just that solution, but I could not find it this morning.

He did however, have a nice review of the narrow blade head for the MkII jig.
https://www.youtube.com/watch?v=sNYzfX1zK-4
Ag
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.