Posts: 14,947
Threads: 0
Joined: May 2005
Location: Oklahoma
I have two sets of hinges from the same source (both marked Made in China, of course) to be installed on the same board. The butler tray hinges are "brushed brass." The sewing machine hinges are "bright brass." I couldn't find them anywhere with matching finishes. What's the chance I can successfully "brush" the bright ones?
Carolyn
Trip Blog for Twelve Countries: [url=http://www.woodworkingtraveler.wordpress.com[/url]
"It's good to know, but it's better to understand." Auze Jackson
Posts: 6,179
Threads: 0
Joined: Dec 2002
Location: Bothell, WA
take some 0000 steel wool to them.
Cellulose runs through my veins!
Posts: 7,964
Threads: 0
Joined: Feb 2006
I vaguely remember something about brass (sometimes?) having a protective finish on it. If steel wool removes that to properly scratch the underlying brass would it need to be put back?
Phydeaux
Posts: 6,686
Threads: 0
Joined: Mar 2005
Location: SW Ohio
A method I've tried before with aluminum and steel - If you have a way of adhering some fine sandpaper to your workbench, you can slide them flat across the paper to get that brushed look. Check after each try. It doesn't take much. This works better than trying to sand the brass by hand using a a folded piece or a block.
Posts: 3,217
Threads: 0
Joined: Jan 2006
Carolyn,
There is a pretty good chance that your brass has a lacquer coating to keep it bright. If I ever strip coated brass I usually soak it in lacquer thinner over night. Then younjust hit it with some p220 sand paper. Just make sure to move the sandpaper in one direction so the scratches stay uniform. If you move the paper in a circular or random pattern the finish will not look right.
Posts: 14,947
Threads: 0
Joined: May 2005
Location: Oklahoma
Then do I need to reapply lacquer?
Carolyn
Trip Blog for Twelve Countries: [url=http://www.woodworkingtraveler.wordpress.com[/url]
"It's good to know, but it's better to understand." Auze Jackson
Posts: 3,217
Threads: 0
Joined: Jan 2006
You can if you want. The lacquer will keep it from getting and antique look over the years. If you don't lacquer them make sure you strip all the brass so they turn at the same rate.
Posts: 14,947
Threads: 0
Joined: May 2005
Location: Oklahoma
Then I will definitely strip and leave bare. I'm not fond of the bright color.
Carolyn
Trip Blog for Twelve Countries: [url=http://www.woodworkingtraveler.wordpress.com[/url]
"It's good to know, but it's better to understand." Auze Jackson
Posts: 10,717
Threads: 1
Joined: Jan 2006
Location: Orlando, Florida
Before you start brushing, make sure they are solid brass. Not brass plated. Especially if they are from China.
Still Learning,
Allan Hill
Posts: 3,217
Threads: 0
Joined: Jan 2006
If you don't like the bright color get yourself a large and small Tupperware container. What you need to do is put the brass inside the large container along with the smaller container. Fill the smaller container with ammonia and fume the brass. Household ammonia works slower than the 29% stuff I use but it still works really well. Just make sure all the coating is stripped and like previously mentioned make sure the hinges are solid brass. If not the fumes could potentially remove the plating.
