01-23-2017, 09:16 PM
The first wheel is a Norton grind stone, quite coarse but can't read the grit specifications on the label. The local blacksmith had worn out the wheel he had, came across this at a flea market for a good price, but by then the blacksmith had purchased a new wheel, so this one has been sitting around for quite a few years. Tired of moving it out of the way, asking ten dollars for it. It's about 17" in diameter, 2 1/2" center hole, 3" wheel width. A few small chips on the edge of the wheel, but seems to be in quite good shape. Asking ten dollars for it, obviously that would NOT include shipping.
The second wheel was originally on a foot-powered grinding setup, the shaft had an offset end for the connection to the treadle. I cut off the end of the shaft and had it hooked up to an electric motor. About 2 1/2 inches wide, 15" in diameter. Asking price is ten dollars. Willing to sell the pair for fifteen dollars.
The second wheel was originally on a foot-powered grinding setup, the shaft had an offset end for the connection to the treadle. I cut off the end of the shaft and had it hooked up to an electric motor. About 2 1/2 inches wide, 15" in diameter. Asking price is ten dollars. Willing to sell the pair for fifteen dollars.