Woodnet Forums › › Active › Woodturning v
Holding small tenons
Thread Modes
Holding small tenons
hairy Offline
Honored Veteran who Shoe horned a win
Posts: 771
Threads: 0
Joined: Jan 2011
Location: Cincinnati
#13
11-29-2017, 12:30 PM
(11-25-2017, 01:36 PM)Bill Mains Wrote: Making ornaments with small urchin shells. Want to turn tenon first n drill small hole then reverse it to  hold the tenon to finish turning the finial. Pin jaws too large and don't want to buy anything.  Thought I saw where someone made a type of compression chuck out of wood to hold small tenon~ any suggestions?

I have a harbor fright drill chuck, 1/2" MT2. It wasn't set up to use as a drawbar when I bought it. All it takes is a drill and tap and some hardware.


Attached Files Image(s)
   
Find
Reply
Dusty Workshop Offline
Member
Posts: 4,789
Threads: 0
Joined: Jan 2005
#14
11-29-2017, 01:22 PM
Another good solution rhat there!
The ALS Association
Lewy Body Dementia Association
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.